Friday, March 11, 2011

Mandrel Bent Exhaust Piping

SuperCircuit special made and tune sized exhaust piping for specific car models.

MANDREL BENT is a special bending process which requires comparatively big mandrel bending machine (easily exceeding the size of a normal van). Due to the cost and space it occupies, no exhaust shop so far in Klang Valley uses this kind of bending machine yet.

In order to provide a better choice for our consumers who are after performance, quality and perfection. SUPERCIRCUIT Exhaust Pro Shop brings you the pre bent mandrel piping for specific car models.

The pre-bent piping has the benifits below:

MANDREL BENT piping has consistent inner diameter along the whole exhaust system. No creases or smaller bends at elbows. Thus free up the exhaust flow by about 35%. Higher efficiency means smoother engine revs. and better fuel economy.

ONE PIECE construction means lesser welding joints, thus less imperfection caused by improper welding or bad welding workmanship.

Mandrel bent pipings are made of high grade stainless steel, guarantee CORROSION RESISTANT and minimise CO2 built up on the inner surface. Thus durable and long lasting performance is ensured.


Toyota Caldina GT4 2.5" pre-bent exhaust piping:

Honda Civic FD2 2.0" pre-bent exhaust piping:

Proton Saga BLM pre-bent exhaust piping:

Suzuki Swift (ZC11) pre-bent exhaust piping:


Please call for more information at SUPERCIRCUIT Exhaust Pro Shop @ Sunway. Tel: +6 03 5632 2855.

No comments:

Post a Comment

Post a Comment