Peugeot 308 Turbo Downpipe

SUPERCIRCUIT catless downpipe for the Peugeot 308 Turbo installed.

The Peugeot factory stock original downpipe is covered by heat shield and can be located easily after you pop the bonnet of the Peugeot 308T. (SEE BELOW) 

Once the heat shield and the factory stock downpipe is removed, the turbo outlet can be seen clearly (SEE BELOW).

Comparing the Peugeot 308 Turbo factoy stock downpipe and the SUPERCIRCUIT 2.5" stainless steel catless downpipe (SEE BELOW). The catless downpipe provides larger and less restrictive exhaust flow, it is good for ECU tuning or ECU reflashing needs.

The original exhaust clamp on the Peugeot 308T.

The installation of the SUPERCIRCUIT downpipe on the Peugeot 308T is just straight bolt-on, no further modification is required. 

The stock original heat shield can be put back in position even after the SUPERCIRCUIT catless downpipe is installed. It is neat and tidy at the engine bay. 

The bottom part of the SUPERCIRCUIT Peugeot 308T Downpipe is to be connected back to the rest of the exhaust system via the exhaust clamp shown earlier in this article. This downpipe is 100% compatible with the stock original Peugeot 308T catback exhaust system.

The O2 sensor defouler is pre-built onto the SUPERCIRCUIT donwpipe, so no CEL issue here.

To purchase or for more information about the above SUPERCIRCUIT bolt-on catless downpipe for the Peugeot 308 Turbo, please visit us at SuperCircuit exhaust Pro Shop, SS13 Subang Jaya Industrial Estate. Tel: 03 5632 2855 or Send Us A Message using the form on the right of this page.

Please join SuperCircuit Exhaust Facebook for more exhaust news and updates.